Advertisement
Install the Spout
- A 1" (25 mm) minimum to 1-1/4" (32 mm) maximum
diameter mounting hole is required.
- Determine the mounting-hole location.
- NOTE: The mounting hardware provided is for a
standard deck thickness of 1/4" (6 mm) minimum to
2" (51 mm) maximum. For a deep rough-in installation
where deck thickness is 2" (51 mm) minimum to 4-1/2"
(114 mm) maximum, order the deep rough-in kit from
kohler.com/serviceparts.
- A 2-1/2" (64 mm) minimum distance is required between
the inished wall and the center of the spout.
- A 1" (25 mm) to minimum to 1-1/2" (38 mm) maximum
distance is required between the sink edge and the center
of the spout.
- Drill a hole through the mounting surface according to the
surface manufacturer's instructions.
- Insert the spout with tubes and wires through the
mounting hole.
- From under the sink, slide the rubber gasket and metal
washer onto the stud.
- If desired, add silicone sealant to the underside of the
escutcheon as needed. Wipe away any excess sealant.
- Thread the nut onto the stud and wrench-tighten to secure
the spout to the mounting surface.
1492164-T01-B
最小
6
安装龙头
最小
最大
感应器
金属垫圈
- 需要一个直径为1" (25 mm)至1-1/4" (32 mm)的安装孔。
- 确定安装孔的位置。 确定安装孔的位置。
- 注意： 随机提供的安装零件可用于厚度为
1/4" (6 mm)~ 2" (51 mm)的标准台面。
当台面厚度为2" (51 mm)~ 4-1/2" (114 mm)且需要进行较深
的安装时， 可订购加长安装工具包。
- 墙壁与龙头底座中心的最小距离应为2-1/2" (64 mm)。
- 洗手池边缘与龙头底座中心的最小距离应为
1" (25 mm) ~ 1-1/2" (38 mm)。
- 按照台面制造商的说明在台面上进行钻孔。
- 将配有导管和导线的龙头插入安装孔。
- 从洗手池底部将橡胶垫片和金属垫圈安在螺柱上。
- 必要时， 可在底座下侧施加硅胶。 将多余的硅胶擦干净。
- 将螺母拧到螺柱上并用扳手拧紧， 从而将龙头固定到台面上。
龙头
螺杆
导管
橡胶垫片
螺母
Advertisement
