Advertisement
CARE AND CLEANING
Do not use any abrasive or harsh cleaners to clean
the faucets.
For best results, keep the following in mind when caring
for your KOHLER product:
Always test your cleaning solution on an inconspicuous
area before applying to the entire surface. Visit Kohler.
com/clean for Kohler faucet cleaner products.
Wipe surfaces clean and rinse completely with water
immediately after applying cleaner. Rinse and dry any
overspray that lands on nearby surfaces.
Do not allow cleaners to soak on surfaces.
Use a soft, dampened sponge or cloth. Never use an
abrasive material such as a brush or scouring pad to
clean surfaces.
Upon cleaning other areas of the restroom be sure the
sensor lenses are protected from other cleaning
chemicals/solvents to prevent potential damages to the
sensor and/or electronics.
It is recommended to lush the system with warm water
every 2 to 3 months.
- Remove and clean the nozzle foaming assembly with
warm water.
- Remove and clean the check valve from the dispensing
tube in the soap reservoir with warm water.
- Fill the soap reservoir with minimal amount of clean
warm water.
- Re-attach the soap reservoir to the control box. Press
the system prime button. Hold the button down until all
of the water has been lushed down until all of the water
has been lushed
- Refill the soap reservoir with soap. Press the system
prime button. Hold down the button until any residual
water is pushed through the pump and soap is dispensed.
1492164-T01-B
保养与清洁
请勿使用任何擦洗剂或刺激性的清洁剂来清洁水龙头。
为了达到最佳效果， 请您在保养科勒产品时牢记以下几点：
在将清洁溶液用于整个表面之前， 先在不明显的区域进行测试。
访问Kohler.com/clean获取科勒水龙头清洁剂产品的信息。
使用清洁剂后立即擦拭表面并用清水彻底冲洗。 清洗并擦干落在
附近表面上的所有过量喷涂物。
请勿使清洁剂在表面上积聚。
使用柔软的湿海绵或抹布。 切勿使用刷子或百洁布等粗糙材料来
清洁表面。
清洁洗手间的其他区域时， 确保感应器镜片不会受到其他清洁化
学品、 溶剂的侵蚀， 避免给感应器和/或电子设备造成潜在损坏。
建议每2至3个月用温水冲洗一次系统。
- 卸下喷嘴发泡组件并用温水清洗。
- 卸下皂液盒中皂液管上的止回阀， 并使用温水进行清洗。
- 用最少量的干净温水充注皂液盒。
- 将皂液盒重新安装到控制盒上。 按下系统起动按钮。 按住按钮， 直
至系统被完全冲洗一遍。
- 将皂液盒注满皂液。 按下系统起动按钮。 按住按钮， 直至将残留的
水推入泵中并排出皂液为止。
16
Advertisement
