Scope Of Delivery; Set Up - Zahl HM1 Manual

SCOPE OF DELIVERY

• HM1 Main Unit
• HMP1 Mains Adapter
• HMP1 Connection Cable
SET-UP
• First read the chapter NOTES, SAFETY INSTRUCTIONS; WARRANTY in this manual.
• Remove the HM1 from its packaging: insert your hands into the foam recesses on the front and back of the unit, reach
your fingers slightly under the unit and then lift it upwards. Do not lift the unit by the knobs or the connectors.
• Remove the HMP1 from the packaging: insert your hands into the foam recesses on the sides of the unit, reach your
fingers slightly under the unit and then lift it out upwards. Do not lift the unit by the connectors.
• Remove the HMP1 connection cable from the packaging. It is equipped with 12-pin connectors on the ends.
• Plug the end with the female connector into the socket on the rear panel or the HM1.
Make sure that the locating peg shows upwards.
• Turn the strain relief nut clockwise. Push the connector slightly after a few turns.
The connector is seated correctly when the rubber seal on the socket is no longer visible.
• Plug the end with the male connector into the socket on the rear panel or the HMP1 Mains Adapter.
Make sure that the locating peg shows upwards.
• Turn the strain relief nut clockwise. Push the connector slightly after a few turns.
The connector is seated correctly when the rubber seal on the socket is no longer visible.
• Check whether the mains voltage setting on the HMP1 Mains Adapter front panel complies to your local mains voltage. If
not, set the voltage selector to the correct voltage. Use a coin or something similar to operate the mains voltage selector.
• Make sure that the mains switch on the rear panel of the HMP1 is in the off position.
• Insert the mains cable.
• Turn the mains switch to the on position.
• On your HM1 unit, press the power on/off button, the power button will illuminate.
• After several seconds the operating indicator (logo sign) right to the power button with illuminate.
Now your HM1 is ready for operation.
Note: The surface of front and rear panel is black anodized with a special matt finish, the lettering is lasered.
All this makes it very durable. Fingernails or other abrasive objects can leave marks on the matt surface.
These can be wiped off very easily with microfibre cloth or similar lint-free cloth.
IMPORTANT! Always follow this order when connecting, otherwise damage may occur!
1. Install HMP1 connection cable
2. Install mains cable
3. Switch on, any order: power switch on HMP1 rear panel and power button on HM1 front panel.
• Mains Cable
• Spare Fuses
• Manual
SCOPE OF DELIVERY & SET-UP | P.5