Magic Bullet Mini juicer User Manual page 9

5
Juice will begin to flow out
Spout Cap
of the and into
Juice Cup
the (or other
container of choice). The
pulp will be separated,
Pulp Bin.
and stored in the
7
When you are done, press
Power Button
the up
OFF
into the position to
stop juicing.
caution:
Wait for the Sieve
completely stop spinning before
removing the Juice Cup from
Spout Cap
under the or starting
disassembly.
16
6
Pulp Bin
When the
completely full, it must be
emptied before continuing
Disassembly
juicing. (See
instructions.)
Additionally, when the
Juice Cup
is at the MAX
line, it must be emptied
before continuing juicing
to avoid spillage.
to
8
is When juicing is completed,
and after the unit is
powered off, remove
the
container of choice) from
under the
note:
Cup,
angle, so the lid's hole has some
separation from the
then you can slide out the cup.
(This is the reverse of what you
did during assembly.) Then,
close the
it upwards, keeping it in place
over the spout. By twisting the
Spout Cap
up, you can avoid any spillage
(such as residual drips onto the
unit or onto the surface below
the
tip:
hand to pull the
from the
the other hand to turn the
Cap UP.
9
Juice Cup
(or other
Spout.
To remove the Juice
tip it forward at a slight
Spout Cap,
Spout Cap
by turning
so the nozzle points
Mini Juicer).
We recommend using one
Juice Cup
away
Mini Juicer, while using
Spout
make sure that
Always
the Mini Juicer is turned
off
after each use.
Power Button
should be in
the up (OFF) position.
caution:
NEVER
unlock the
Locking Arms Juice
from the
Bowl Sieve
while the is still
rotating. Always wait until the
unit is completely powered
Sieve
off, and the as stopped
rotating before starting
disassembly.
17