Download Print this page

Advertisement

Quick Links

VIM1S Quickstart Guide
Setup
1
2
3
5V
ANT-V-MO2.
4
OOWOW Introduction
VIM1S comes with the OOWOW embedded service.
Use OOWOW to install your preferred OS directly from
the Cloud.
1
OOWOW will start automatically if the device storage is empty.
Control VIM1S with a display and keyboard, or remotely over
WiFi/LAN.
With OOWOW you will always be in control of your VIM1S.
Activate OOWOW: hold
Function
and press
Reset
Activate Hotspot: press
Function
after OOWOW starts
Network Name: vim1s-xxxxx (last 5 digits of serial no.)
Further information: https://docs.khadas.com/oowow
Website Introduction
For more documentation and technical information,
you can visit docs.khadas.com.
If you encounter technical issues during development,
seek help at forum.khadas.com.
To purchase additional accessories, please visit
shop.khadas.com.
Data Download Instruction
Schematics: dl.khadas.com/products/vim1s/schematic/
Datasheets: dl.khadas.com/products/vim1s/datasheet/
Specification: dl.khadas.com/products/vim1s/specs/
2D DXF: dl.khadas.com/products/vim1s/dxf/
3D CAD: dl.khadas.com/products/vim1s/cad/
After-Sales Service
Please email support@khadas.com if you have any
after-sales related questions.
2
To get started, visit
docs.khadas.com/vim1s

Advertisement

loading
Need help?

Need help?

Do you have a question about the VIM1S and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for KHADAS VIM1S

  • Page 1 Setup OOWOW will start automatically if the device storage is empty. Control VIM1S with a display and keyboard, or remotely over WiFi/LAN. With OOWOW you will always be in control of your VIM1S. Activate OOWOW: hold Function and press Reset...
  • Page 2 (750mA) (5V) (SDXC) MHF2 Antennas Header (WiFi & BT) Reset Function XPWR Pads Programm- Power able MCU VIM1S V11 (STM8S003) 2206 2228 Header (White & Red) 2-Channel 40-Pin Header SPI Flash Infrared (I2C, I2S, UART, PWM, ADC, USB, S/PDIF, MCU-I/O)
  • Page 3 The final end product must be labeled in a visible area with the following" Contains FCC ID:2A8Q4- · Connect the equipment into an outlet on a circuit different from that to which the VIM1S". receiver is connected. · Consult the dealer or an experienced radio/TV technician for help.
  • Page 4 3.93dBi For 5.8GWIFI 2.8 Label and compliance information The final end product must be labeled in a visible area with the following" Contains FCC ID:2A8Q4-VIM1S ". 2.9 Information on test modes and additional testing requirements Host manufacturer which install this modular with single modular approval should perform the test of radiated emission and spurious emission according to FCC part 15C:15.247/FCC part 15E:15.407 and 15.209 requirement, only if the test result...