Advertisement
Manual
Valid for
9.2. Connection of the speakers
When connecting the speakers, you can choose for each zone whether you want to operate it as a low-
resistance version (4 ohms) or in 100V ELA technology (speakers with transformer / longer transmission
paths).
Note:
NEVER mix the two technologies in one zone!
Pay attention to the correct polarity when connecting the speakers!
When connecting the speakers, make sure that the dimensions are correct.
With 100V technology, the total power of the speakers must not exceed 200 W per zone!
With low-resistance connections, the total impedance of the loudspeakers must not be less than 4 ohms!
10. Operation
10.1. Connections
Connect the 230V cable (2) to the device and switch on the amplifier (3).
Select TRIGGER (T) if needed.
(1)
(T)
(3)
10.1.1. Configuration without a network (direct access)
For configuration, plug an Ethernet crossover cable into your PC / laptop, ... (1) and open your web
browser.
Enter the following default IP address in the start bar of the browser: 192.168.14.1
Default password:
Username: admin
Password: admin
This opens the configuration interface.
Version (modifications reseverd)
AMP 4200
111-425-04-001-00
Seite 4 of 17
(2)
21.02.2022
Advertisement
