Advertisement
A. IP Scan - Scanning TRK device by entering the specific IP address, an IP segment or
multiple IP segments. There should be a comma symbol between two different IP
segments.
B. Multicast - Scanning by IP Multicast protocol.
C. Manual (from a file) - Loading TRK system devices by loading the TRK devices list file.
For example,
Choose IP Scan and enter IP address segment 192.168.3.60-3.70, then click "Scan" button to
start scan TRK system devices in the network.
After the scanning process completed, all TRK devices connected to this network will be
showed on the left Device list area. There will be a message under the list to report the
total number of TRK devices found and the number of online TRK devices.
The Searching settings will be stored after completing scanning process and then click
"Close" button to enter the main page.
Note: "Search settings" page can be opened through TRK Manager Tool drop-down list.
2) SCAN
Click the scan button
the scanning process with the searching settings stored last time.
3) TRK Manager Tool Drop-down List
Click the TRK Manager Tool Drop-down List on the top right corner, as shown in the following
figure.
on the top right corner in the main page, the TRK Manager will run
Advertisement
