Ds Pack Operation; To Turn Lights On Now; Setting The Test Switch Bump Or Latch Action And Level - NSI DS12 Installation And Operation Manual

___________________________________________________________________

DS Pack Operation

The Operation of the DS Pack has been divided into the following sections:
1. Turn Lights On...Now!
2. Setup
3. Softpatch
4. Analog Submasters
5. Presets
6. Dimmer Feedback
7. Control Module Jumper Settings
8. Contact NSI
__________________
Section 1

To turn lights on now:

1.1 Setting the Test Switch Bump or Latch action a nd level:
If the test switches have been configured as " latch" action, the lights will stay on at the first press of the test switch,
but if the test switches have been configured as "bump" action, they will only stay on as long as they are pressed.
To change the test switch action, and the test switch intensity, press [CLEAR] until the following menu is displayed:
NSI DSxx
STATUS=xxx [MORE]
Now press the switch under [MORE] twice. This switch is a soft switch, that is, the function of the switch is defined
by the bracketed text in the LCD window above. If you are lost or make a mis-entry, just hit [CLEAR]. The menu
will back up one position or one menu each time [CLEAR] is pressed. The LCD should now display:
NSI DSxx
[SETUP]
Press the soft switch under [SETUP]. Then press [MORE] 2 times. The screen should now display :
SET TEST SWITCH
[ACTION] [MORE]
Select [ACTION]. Two choices will be displayed [LATCH] and [BUMP]. Press the test function you prefer.
This selection will stay in permanent EEPROM memory. Upon selection, another choice will appear:
SET TEST LEVEL = 25%
[CHANGE]
If you wish to change the output intensity of the bump switches, select [CHANGE]. This change is in volatile
memory, or RAM , so it will go back to 25% when the power to the pack turned off. The level setting will not take
effect, however, until the test switch is activated again.
NSI DS8/DS12 MODULAR DIGITAL DIMMING SYSTEM
Software Revision 1.1x, 8/24/99
1. Make sure all three red led power indicators on the front are lit.
2. Make sure lighting loads are plugged into back of pack .
3. Flip all circuit breakers up to "ON" position.
4. Press test switch oval under each circuit breaker.
xPHASE Note: the 'x's could indicate a variety of settings
xPHASE
[MORE]
[MORE]
- 6 -