Table of Contents
Advertisement
en Basic settings
13 Basic settings
You can configure the basic settings for your appliance to meet your needs.
13.1 Overview of the basic settings
Here you can find an overview of the basic settings and factory settings. The basic settings depend on the features
of your appliance.
Display
Basic setting
Button tone
Demo mode
Factory setting (may vary according to model)
1
13.2 Changing basic settings
Requirement: The appliance is switched off.
Press and hold
and
1.
a The display shows for the first basic setting.
To edit the basic setting, press
2.
a The selected setting lights up in the display.
Use the rotary selector to set the required selection.
3.
To accept the basic setting, press
4.
5.
To exit the basic setting, press
Use the rotary selector to change to the basic set-
6.
ting .
7.
To edit the basic setting, press
a The selected setting lights up in the display.
Use the rotary selector to set the required selection.
8.
To accept the basic setting, press
9.
To exit the basic setting, press
10.
To exit the basic settings menu, press
11.
Tip: You can change this setting again at any time.
14 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
14.1 Cleaning products
Only use suitable cleaning agents.
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
Do not use steam- or high-pressure cleaners to
▶
clean the appliance.
14
Selection
= off
1
= on
1
= off
= on
for a few seconds.
.
.
.
.
.
.
again.
Description
Switching the button tones on or off
Note: You cannot switch off the button tone for
.
The appliance is switched off. You can use the buttons
and the display. The buttons have no function, meaning
that no power arises for the microwave, for example.
Dealers predominantly use the demo mode.
While the demo mode is activated, the display shows
13.3 Changing the signal duration
When your appliance is switched off, you hear an aud-
ible signal. You can change the duration of the signal.
Press and hold
▶
a The signal duration switches between short and
long.
a The appliance applies the signal duration and dis-
plays the time.
13.4 Changing the time
You can change the time on the clock at any time.
Press
.
1.
Set the time using the rotary selector.
2.
3.
Press
to confirm the time.
13.5 Hiding the clock in standby
You can hide the clock when the appliance is in
standby mode.
Press
.
1.
Press
.
2.
to display the clock again.
Note: Press
ATTENTION!
Unsuitable cleaning agents damage the surfaces of the
appliance.
Do not use harsh or abrasive cleaning products.
▶
Do not use cleaning products with a high alcohol
▶
content.
Do not use hard scouring pads or cleaning
▶
sponges.
Do not use any special cleaners for cleaning the ap-
▶
pliance while it is hot.
Only use glass cleaners, glass scrapers or stainless
▶
steel care products if recommended in the cleaning
instructions for the relevant part.
for approx. six seconds.
and
.
Advertisement
Table of Contents
