Table of Contents
Advertisement
en Automatic switch-off
Setting the correct time
Press
repeatedly until
1.
Set the time on the control panel again.
2.
Switching off the timer signal
You can switch the signal off manually.
Press any touch field.
▶
a The display goes out and the signal tone stops.
8.3 Stopwatch function
The stopwatch function displays the time which has
passed since activating the function.
The stopwatch function only works when the hob is
switched on. When the hob is switched off, the stop-
watch function is switched off as well.
9 Automatic switch-off
If you do not change the settings of a hotplate for a
long time, automatic switch-off will be activated.
When the hotplate switches off depends on the heat
setting selected (1 to 10 hours).
The heat to the hotplate is switched off. and the re-
sidual heat indicator / flash alternately on the hot-
plate display.
10 Wipe protection
Wiping over the control panel while the hob is switched
on may alter settings. Your hob has a wipe protection
function to prevent this.
The main switch is excluded from the wipe protection
function. You can switch the hob off at any time.
11 Energy consumption display
This function indicates the total amount of energy con-
sumed between switching the hob on and switching it
off again.
Once switched off, the energy consumption is dis-
played in kilowatt hours, e.g. 1.08 kWh, for
10 seconds.
10
lights up.
Switching on the stopwatch function
Press
repeatedly until
1.
appears on the timer display.
a
Press anywhere on the control panel.
2.
a The time measurement begins.
a Seconds are displayed during the first minute, then
minutes.
Switching off the stopwatch function
Press
repeatedly until
1.
Press anywhere on the control panel.
2.
a The timer display goes out.
9.1 Continuing cooking after automatic
switch-off
Press any touch field.
1.
a The display goes out.
Set the required power level for the hotplate again.
2.
10.1 Activating wipe protection
Press .
▶
a A signal tone sounds.
lights up brightly.
a
a The control panel remains locked for 30 seconds.
The accuracy of the display depends on various factors
such as the voltage quality of the power supply.
The display can be activated in the basic settings.
→ Page 11
lights up.
lights up.
Advertisement
Table of Contents
