Operation; Basic Setup - Linking Devices; Unlinking Devices; Individual Unlink - Wireless Solution W-DMX MicroBox G6 User Manual

W-DMX MicroBox G6

Operation

All W-DMX™ G6 devices uses similar user interfaces, however some model-specific differences may
apply.
Basic setup – Linking devices
A basic setup is defined by the link between two devices. This means that, in order to send data from a
transmitter to a receiver, it's necessary to link the devices:
Press the red function button, on the transmitter momentarily and the LINK LED starts flashing.
Figure 4: Front panel overlay
NOTE: All available (currently unlinked) receivers, as long as they are turned on and compatible with
the transmitter's radio mode, will pair with this transmitter. The LINK LED of each receiver will flash for
5 seconds, and then stay static once linked up.
There is no limit of the number of receivers that can link up with a transmitter – there can be an infinite
number of receivers all paired with a single transmitter.

Unlinking devices

There are two ways to unlink devices – individual unlink, or group unlink:

Individual unlink

Press and hold the red function button, on each receiver that you wish to unlink, for at least 3 seconds.
The LINK LED will turn off.
Wireless Solution Sweden AB
2022-09-30
9