Table of Contents
Advertisement
W-DMX MicroBox G6
Group unlink
Press and hold the red function button on the transmitter for at least 3 seconds. This will unlink all
currently powered receivers that are linked to this transmitter.
Linking multiple transmitters with multiple receivers
When multiple receivers need to be linked up with different transmitters, repeat the process in 6.1., but
turn off all receivers you do not wish to pair up. For example:
• If you have 2 transmitters and 10 receivers, pair the first transmitter to 5 receivers, while the last
five are turned off.
• After that, turn the last five receivers, and pair them to the second transmitter.
NOTE: This will not affect any receiver that has already been paired up.
Switching FLEX mode
F-1 units can be changed between transmitter or receiver.
FLEX mode determines if the unit is used in transmit mode (TX) or receive mode (RX):
1. Press the red function button rapidly 5 times.
2. Press and hold the red function button for at least 3 seconds.
3. The LINK and DATA LEDs will flash alternating.
4. Each time you press the red function button you will step through the available modes, this will
be indicated by a flashing RX or TX LED.
5. Press and hold the red function button
Changing MODE
There are a few operating modes within all W-DMX™ products using different generations of the com-
munication protocol. The W-DMX G6 supports several modes to maximize compatibility with different
generations of equipment. When operating as an RX the device will automatically switch to the correct
mode depending on the mode of the transmitter that is linking to it.
The following modes are supported when operating as an RX (CRMX requires the CRMX option):
Wireless Solution Sweden AB
2022-09-30
10
Advertisement
Table of Contents
