Datalogic MC-P096 Quick Reference Manual page 2

Multi-slot battery charger

Hide thumbs

page of 2

/ 2
Bookmarks

MC-P096 Master body

Power LED

Battery charging LEDs

SURFACE MOUNTING

The Master and the Extension unit packages contain a clip, two screws and a bracket for fixing purposes.

To fix the unit to a DIN guide:

1. Use the screws to fix the clip to the bottom side of the unit;

2. Insert the clip into the DIN guide.

To fix the unit to the bracket:

1. Fix the bracket on a flat surface using screws (not included);

2. Use the screws to fix the clip to the bottom side of the unit;

3. Insert the clip into the fixed bracket.

Clip

To release the unit:

1. Keep pressing the clip;

2. Remove the unit from the DIN guide or bracket.

NOTE: For MBC with multiple extension units, mount the clips only on the master unit and on the last extension unit to easily remove the

MBC from the DIN rail or bracket.

MC-P096 Extension body

Battery charging LEDs

TECHNICAL SPECIFICATIONS

PHYSICAL CHARACTERISTICS

ELECTRICAL CHARACTERISTICS

Master unit:

72x70x87mm

Dimensions

Power Supply

Extension unit:

76.5x70x87mm

MC-P096-E2:

130g

Weight

MC-P096-M2:

160g

Max. Consumption

MC-P096-M4:

290g

Green: Power-On

LEDs

Charge Time

Red/Yellow/Green: Charging state

CAUTION: The Multi-Slot Battery Charger MC-P096 should be operated at an ambient temperature between 0 and 35 °C (32 to 95 °F) to

achieve the maximum charging rate. Never charge the battery packs in a closed space where excessive heat can build up. As a safety pre-

caution, the battery charging may stop or slow down to avoid overheating.

FCC COMPLIANCE

Modifications or changes to this equipment without the expressed written approval of Datalogic could void the authority to use this equipment.

This device complies with PART 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interfer-

ence, and (2) this device must accept any interference received, including interference which may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will

be required to correct the interference at his own expense.

POWER SUPPLY

This device is intended to be supplied by a UL Listed/CSA Certified Power Unit marked "Class 2" or LPS power source rated 12 VDC, minimum 60 W,

which supplies power directly to the device.

WEEE COMPLIANCE

For information about the disposal of Waste Electrical and Electronic Equipment (WEEE), please refer to the website at

Datalogic and the Datalogic logo are registered trademarks of Data-

logic S.p.A. in many countries, including the U.S. and the E.U.

ENVIRONMENTAL CHARACTERISTICS

0° to + 40 °C

12 VDC

Working Temperature