Advertisement
2. Remove the screws on the steering wheel.
3. Install the switch bracket onto the steering wheel
and secure the bracket with the previously removed
hardware (Figure 3).
2
1
1. Foam paddle switch
4. Install the decal onto the switch bracket.
3
Installing the Finishing Kit
Bracket
Parts needed for this procedure:
1
Foam marker (sold separately)
1
Foam marker bracket
4
Bolt (1/4 inches)
4
Bolt (3/8 inches)
4
Nut (1/4 inches)
4
Nut (3/8 inches)
Procedure
1. Secure the bracket to the machine using 4 bolts (3/8
inch) and 4 nuts (Figure 4).
Figure 3
2. Foam on/off switch
2. Attach the foam marker (sold separately) using 4 bolts
(1/4 inch) and 4 nuts (1/4 inch) (Figure 5).
g023700
Operation
Using the Controls
Foam paddle switch—activates the compressor, generating
a flow of foam and air to the right or left boom section
(Figure 3).
Foam on/off switch—activates the compressor, generating
a flow of foam to both of the boom sections simultaneously
(Figure 3).
Indicator markings—located on the side of the tank; they
indicate the solution level in the tank.
Foam regulator adjustment valve—controls the
consistency of the foam solution. Adjusting the valve controls
3
Figure 4
Figure 5
g023695
g023696
Advertisement
