Advertisement
Procedure
3
1
Routing the Wiring Harness
Parts needed for this procedure:
1
Wiring harness
Removing the Hood
1. While grasping the hood in the headlight openings, lift
up on the hood to release the lower mounting tabs
from the frame slots (Figure 1).
1. Hood
2. Pivot the bottom of the hood upward until you can pull
the top mounting tabs from the frame slots (Figure 1).
3. Pivot the top of hood forward and unplug the wire
connectors from the headlights (Figure 1).
4. Remove the hood.
Description
Foam marker (sold separately)
Foam marker bracket
Bolt (1/4 inches)
Bolt (3/8 inches)
Nut (1/4 inches)
Nut (3/8 inches)
Figure 1
Qty.
1
1
4
Install the finishing kit bracket.
4
4
4
Installing the Hood
1. Connect the lights.
2. Insert the top mounting tabs into the frame slots.
3. Insert the lower mounting tabs into the frame slots.
4. Ensure that the hood is fully engaged in the top, sides,
and bottom grooves.
Routing the Wiring Harness
Route the wiring harness as shown in Figure 2.
g023697
2
Installing the Switches
Parts needed for this procedure:
1
Switch bracket
1
Rocker switch
1
Paddle switch
1
Decal
Procedure
1. Install the switches onto the switch bracket.
2
Use
Figure 2
Advertisement
