U-Line H-1480 Assembly

π
H-1480
CONVERTIBLE ALUMINUM HAND TRUCK
TOOls NEEDED
10mm Wrench
PAGE 1 OF 4
13mm Wrench
AssEmbly
ATTACH HANDLEs
1. Align holes in handle and extended handle. slide
ATTACH NOsE PLATE AND AXLE sUPPORT
Figure 1
1.
2. Align axle support with outside rail of frame. Make
3. Thread four 13mm bolts through the axle support,
ATTACH AXLE AND WHEELs
Figure 2
1.
2. slide a spacer and a washer onto each end of the
Figure 3
3. Tighten all locknuts.
4. Check tire pressure. (30 psi max.) Inflate if necessary.
Figure 4
1-800-295-5510
uline.com
Pliers
NOTE: Do not use air or power tools.
washers onto four 10mm bolts. Insert bolts through
handle and extended handle and secure with
locknuts. (see Figure 1)
Position frame reinforcements against bottom
frame rail. slide nose plate into channel on frame
reinforcement. (Keep bolt holes aligned.)
sure axle support is positioned as shown in Figure 2.
frame, frame reinforcement and nose plate. secure
with locknuts but DO NOT tighten.
Insert wheel axle through hole in axle supports.
Align holes in axle with grooves on back of the axle
support. Use a hammer to tap in the round pins.
(see Figure 3)
axle. slide a wheel onto each end of the axle. slide
on a washer, then secure wheel with a cotter pin.
Bend cotter pin using pliers. Wheels should spin
freely. (see Figure 4)
Para en Español, vea páginas 3-4.
Hammer
0813 IH-1480