Toshiba TOSVERT VF-A5 Series Option Manual page 15

TOSHIBA
E6580704
Setting [ 11:] (input terminal selection) under
[Gr.SI:]
to [ /] (individual setting)
enables the 6. and
'::J keys on the panel to be used to read out parameters
[ /I: D] (input terminal 0 (R) function selection) through [ 11: I I] (input terminal 11
virtual terminal function).
Parameters [ 11: D] (input terminal O (R) function) through [ 11: I I] (input terminal
11 virtual terminal function) correspond to the inverter terminals as described
below:
Inverter standard LED display code Function and default setting
terminal name
R
[ 11:
DJ
[D] (Reverse operation)
81 [ 11: I] [
/]
(SS1:15-step multispeed operation)
S2
[ 11:
2] [2]
(SS2:15-step multispeed operation)
S3 [ 11: 3] [ 3] (SS3: 15-step multispeed operation)
S4
[ I
I: Y] [ Y] (SS4: 15-step multispeed operation)
F [11:5] [ 5] (Forward operation)
RES
[ / l:
6] [6]
(Failure reset)
ST
[ / l: 'l]
[ 'l] (Gate ON/OFF)
SS [ / l: 8] [8] (Change JOG)
S6 [ 11: 9] [ 9] (Change AD2)
S7
[ I l:
I
rl]
IU
[ I
0] (Emergency stop)
Virtual terminal
[ I l: I I]
[ 3 3]
(Uncontrolled)
(normally closed)
Unused terminals from [ / l: 0] to [ / l: I I] are set to [ Y 2] (write binary data).
3) Set [DP l:] (optional board selection) under [G ,- .l: ,- ] to [ 5] (3-digit BCD input in 0.1 Hz
increments).
4) The inverter' s frequency command can now be set according to the following
equation:
I
Frequency Command = BCD data
x
0.1 (Hz)
• Using the BCD code to set the frequency in 1 Hz increments
1. The VF-A5 uses a blind function to concea,I the parameters, so it is necessary to
cancel the blind function for the parameter groups that are needed. For directions
on canceling the blind function, see the VF-A5 Instruction Manual.
Necessary parameter groups [ [,
r.
5
l:]
[Gr.tr]
2. When a binary data write input switch is not used, set [ I l:] (input terminal
selection) under [ [,
r.
5
l:] to [
0]
(standard terminal function).
- 12 -