BMW X2 2022 Owner's Manual page 174

CONTROLS
Press and hold this button.
The indicator light in the instrument
cluster lights up.
To switch distance control back on, press but-
ton again briefly.
After changing over distance control, a Check
Control message is displayed.
Displays in the instrument cluster
Set speed and stored speed
▷ Mark lights up green: system
is active, the mark indicates
the set speed.
▷ Mark lights up orange: sys-
tem is interrupted, the mark
indicates the stored speed.
▷ The mark does not light up: the system is
switched off.
Brief status display
Selected set speed.
If no speed is indicated, it is possible that the
conditions necessary for operation are not cur-
rently fulfilled.
Distance to vehicle ahead of you
Selected distance to the vehicle ahead of you
is shown.
Distance display
Distance 1
Distance 2
174
Driving comfort
Online Edition for Part no. 01405A540A1 - II/22
Distance display
Distance 3
Distance 4
This value is set automatically after
the system is switched on.
Detected vehicle
Icon lights up orange:
A vehicle has been detected ahead of
you.
Rolling bars: the detected vehicle has
driven away.
The system does not accelerate. To acceler-
ate, activate the system by briefly stepping on
the accelerator pedal or pressing the
RES CNCL button or the rocker switch.
Indicator/warning lights
Icon flashes orange:
The conditions are not adequate for
the system to work.
The system was deactivated but applies the
brakes until you actively resume control by
pressing on the brake pedal or accelerator
pedal.
Icon flashes red and a signal sounds:
You are requested to intervene by
braking or making an evasive maneu-
ver.
The system has been interrupted or
distance control is temporarily sup-
pressed because the accelerator pedal
is being pressed; a vehicle was not detected.
Distance control is temporarily sup-
pressed because the accelerator pedal