Advertisement
5.1.2
Check of condition of the power cable
FOR EVERY NEW USE: check the power cable.
• Before connecting the plug to the
power socket, check visually and by
touch that the protective sheath of
the cable is intact, that the wires are
not exposed and that the plug is not
damaged.
WARNING! If the power supply
cable is damaged in any way,
have it replaced by a specialised
technician.
5.1.3
Thorough cleaning of the grinders
EVERY MONTH: Clean the grinders with a suitable product (e.g. Grindz ™ Grinder
Cleaner) following the instructions on the package
5.1.4
Temporary decommissioning
If the appliance is to be set aside for a relatively long period of time, it is recommended
that you perform the following operations to keep it in good condition and avoid possible
problems the next time you restart it.
WHEN NECESSARY: cleaning the appliance and setting it aside.
• Carefully clean the coff ee grinder as
instructed in section 5.1.1.
• Thoroughly clean the grinders as
instructed in section 5.1.3.
• Unplug the cable from the power socket
and wind it around the appliance.
• Cover the appliance with a tea towel to
protect it against dust and dirt.
• Store the appliance in a dry, safe and
secure place.
20 / 28
STILE
STILE
EN
EN
1
0
1
0
STILE_05.2022
5.1.5
Replacement of the grinders
WARNING! The grinders must be replaced by a specialised technician.
5.1.6
Final decommissioning
If the appliance is to be permanently decommissioned, empty the hopper of any coff ee,
remove the plug from the socket and cut the power cord.
Finally, pack the coff ee grinder using cardboard or other types of packaging and deliver
the appliance to a collection centre authorised to dispose of electronic waste as indicated
in chapter "7.2 - Disposal"
6
TROUBLESHOOTING
Fault
Cause
The doser grinder
Lack of power.
does not turn on.
The doser grinder
Feed hopper
starts but does
empty.
not grind coff ee.
Closed shutter.
The appliance
The hopper is
does not start the
not correctly
grinding cycle
positioned
when the keys
and the safety
microswitch
,
,
in the body of
or the microswitch
the appliance
are pressed (see
prevents the
section 4.2.2).
motor from
starting.
STILE_05.2022
STILE
STILE
Solution
• Make sure that the power plug is
correctly inserted in the socket;
• Make sure that the switch is in the "I"
(ON) position;
• Make sure there is mains power and that
the circuit breaker and the main switch
are switched on.
• Check the condition of the power cord
and plug. If damaged, have them
replaced by a qualifi ed technician.
• Load the hopper with the coff ee beans to
be ground.
• Open the shutter to allow the coff ee beans
to descend into the grinding chamber.
• Correctly position the feed hopper making
sure to couple it perfectly to the body
of the appliance to activate the safety
microswitch and enable the motor to
function.
EN
EN
21 / 28
Advertisement
