Technical Specifications; Controls And Functions; Material / Paint Selection - Hyundai HSPA800-AC Original Instructions Manual

5. Technical specifications

Voltage and frequency
Power
Flow rate
Maximum pressure
Net Weight
Temperature
IP(Ingress Protection)
Insulation class
Guaranteed sound power level

6. Controls and Functions

 ON/OFF Switch (10):
The ON/OFF Switch (10) turns the power to the sprayer ON ("I") and OFF (0")
 Prime/Spray Switch (11):
The Prime/Spray Switch (11) directs fluid to the Spray Hose (1) when set to SPRAY or to the
Return Hose (13) when set to PRIME. The Prime/Spray Knob is also used to relieve pressure
built up in the Spray Hose (refer to Pressure Relief Procedure ).
 Pressure Gauge (8):
Optional accessory that identifies the amount of force the pump uses to push the fluid through
the Spray Gun (6).
 Suction Hose (16):
Fluid is drawn through the Suction Hose (16) into the pump.
 Return Hose (13):
Fluid is sent back through the Return Hose (13) to the original container when Prime/Spray
Switch (10) is in PRIME position.
 Suction Hose Filter (1 5):
Strains the spray material to prevent the system from being clogged.
 Spray Gun (6):
Controls the delivery of the fluid being pumped.
 Spray Hose (1):
Connects the Spray Gun (6) to the pump.
 Lance (1 9):
Optional accessory that can be attached to the end of the Spray Gun (6) to spray hard to reach
areas.

7. Material / Paint Selection

Do not use textured wall paints or coatings as this will block the spray gun tip and
damage internal components of the Airless Spray Station.
Although a large number of paints and materials can be sprayed, some cannot. Please check the
manufacturers' recommendations before purchasing paint.
MATERIALS WHICH CAN BE USED:
230-240 V˜ 50 Hz
800W (max.1010 W)
1.5 L/min
22.7MPa
7.2 kg
Min.10°C/ Max 40°C
IPX0
II
110dB(A)
9