Table of Contents
Advertisement
9. Pre-Operation
WARNING! Ensure the machine is disconnected from the power supply before
performing any of the following operations.
This section contains instructions that will be repeated throughout this manual. Read and
understand this section before using the equipment.
Locking the Spray Gun Trigger
The spray gun Trigger (3) should be locked prior to preparing the spray station to
ensure the Trigger (3) is not accidentally pressed.
Lock the spray gun Trigger (3) whenever instructed.
1. To LOCK the Trigger (3), rotate the Trigger Locking Switch backwards towards the rear end of
the spray gun (6) until it stops (Fig.4a).
2. To UNLOCK the Trigger (3), rotate the Trigger Locking Switch forward towards the Trigger
Guard (2) until it stops (Fig.4b).
Pressure Relief Procedure
Always follow the Pressure Relief Procedure when shutting the machine off for any
purpose. This procedure is used to relieve pressure from the Spray Hose (1). Failure to do
so may result in serious injury.
Never aim the Spray Gun (6) towards at any part of your body, other people or animals.
Perform the Pressure Relief Procedure whenever instructed in this manual.
1. Lock the spray gun Trigger (3) by rotating the Trigger Locking Switch towards the rear end of the
Spray Gun (6) (Fig.5a).
2. Turn the Prime/Spray Switch (11) to the "PRIME" position by turning the Prime/Spray Switch (11)
upwards (Fig.5b).
3. Turn OFF the machine by pressing "O" on the On/Off Switch(10) (Fig.5c).
4. Unlock the spray gun Trigger (3) by rotating the Trigger Locking Switch towards the Trigger
Guard (2) until it stops (Fig.5d). Then briefly pull the spray gun Trigger (3) into the side of a waste
bucket to fully relieve pressure from the system.
5. Lock the spray gun Trigger (3) (Fig.5a)
12
Advertisement
Table of Contents
