Table of Contents
Advertisement
4. After confirming that the steel ball is loose, reassemble all parts according to the reverse
program: fully insert the suction tube (arrow 2) into the lower suction valve by hand
Long Term Storage
Follow all cleaning procedures after each use. Ensure the unit is thoroughly cleaned before storing
to prevent build-up of dried paint which may cause blockages and stop the unit from working.
1. Perform ALL cleaning procedures
2. Remove the Spray Hose (1).
3. Remove the Suction Hose (16) from the Suction Hose Inlet Port (17) by squeezing the dogleg
pin.
4. Remove the Return Hose (13) from the Return Hose Inlet Port (12) by unscrewing the nut.
5. Turn the machine upside down. Add 3Omls of household oil or a pump protector oil into each
inlet port.
6. Set the Prime/Spray Switch (11) to "SPRAY" position.
7. Hold a rag over the Spray Hose Outlet Port (18).
8. Switch ON the machine for 5 SECONDS by pressing the "I" on the On/Off Switch (10). Then
Switch OFF the machine by pressing the "O" on the On/Off Switch (10).
9. Set the Prime/Spray Switch (11) to "PRIME" position.
10. Replace the Suction Hose (16) to the Suction Hose Inlet Port (17), and use the dogleg pin to
secure the Suction Hose (16) in place.
11. Replace the Return Hose (13) to the Return Hose Inlet Port (12).
12. Wipe the sprayer housing with a clean dry cloth.
13. Store the sprayer and its accessories in a clean, dry location, out of the reach of children.
14. Disposal Instructions
Tools that are no longer usable should not be disposed of with household waste but in an
environmentally friendly way. Please recycle where facilities exist in your area. Check with your
local council authority for recycling advice.
Dispose of hazardous waste, such as paint, varnishes and thinners safely. Contact your local
council authority for advice on disposal and recycling services.
27
Advertisement
Table of Contents
