Download Print this page

Icom IC-M506 Instruction Manual page 4

Hide thumbs Also See for IC-M506:

Advertisement

PRECAUTIONS
RWARNING! NEVER
outlet. This could cause a fire, electric shock and damage the
transceiver.
RWARNING! NEVER
er source of more than 16 V DC, such as a 24 V battery. This
could cause a fire and damage the transceiver.
RWARNING! NEVER
larity when connecting to a power source. This could cause a
fire, electric shock and damage the transceiver.
RWARNING! NEVER
DC cable. This could cause a fire, electric shock and damage
the transceiver.
RWARNING! NEVER
lightning storm. It may result in an electric shock, cause a
fire or damage the transceiver. Always disconnect the power
source and antenna before a storm.
CAUTION: NEVER
operation of the vessel may be hindered or where it could
cause bodily injury.
KEEP
the transceiver and microphone at least 1 m away
from the vessel's magnetic navigation compass.
DO NOT
place or leave the transceiver in areas with tem-
peratures below –20°C or above +60°C or, in areas subject to
intense sunlight, such as the dashboard.
iii
connect the transceiver to an AC
connect the transceiver to a pow-
reverse the DC power cable po-
remove the fuse holders on the
operate the transceiver during a
place the transceiver where normal
DO NOT
use harsh solvents such as benzine or alcohol to
clean the transceiver, as they will damage the transceiver's
surfaces. If the transceiver becomes dusty or dirty, wipe it
clean with a soft, dry cloth.
DO NOT
disassemble or modify the transceiver for any rea-
son.
BE CAREFUL!
The transceiver rear panel will become
hot when operating continuously for long periods of time.
Place the transceiver in a secure place to avoid inadvertent
use by children.
BE CAREFUL!
The transceiver meet IPX8 requirements
and the optional HM-195
commandmic IV
quirements for waterproof protection. However, once the
transceiver has been dropped, waterproof protection cannot
be guaranteed because of possible damage to the transceiv-
er's case or the waterproof seal.
* Except for the DC power connector, NMEA In/Out leads and AF
Out leads.
Icom, Icom Inc. and Icom logo are registered trademarks of Icom Incorporated
(Japan) in Japan, the United States, the United Kingdom, Germany, France,
Spain, Russia, Australia, New Zealand, and/or other countries.
COMMANDMIC is a registered trademark of Icom Incorporated (Japan) in Ja-
pan and the United States.
™ meet IPX7 re-

Advertisement

loading
Need help?

Need help?

Do you have a question about the IC-M506 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

This manual is also suitable for:

Ic-m506euro