Lenovo ThinkPad X300 6477 Supplementary Manual page 50

7. With the notched end of the SO-DIMM toward the contact edge side of
8. Reinstall the cover of the memory slot by aligning the side of the cover
42
®
ThinkPad X300 Service and Troubleshooting Guide
the socket, firmly insert the SO-DIMM into the socket at an angle of
about 20 degrees 1 ; then pivot it downward until it snaps into place
2 .
1
1
Note: If you install a memory module in only one of the two memory
slots, install it in the slot on which "SLOT-0" is printed.
first 1 , and closing the cover 2 . Then tighten the screws to secure the
cover 3 .
2
2