Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for AEMC instruments Simple Logger II Series
Summary of Contents for AEMC instruments Simple Logger II Series
- Page 1 Quick Start Guide ENGLISH Simple Logger ® Series DATA LOGGERS WITH AEMC INSTRUMENTS ®...
- Page 2 Statement of Compliance Chauvin Arnoux , Inc. d.b.a. AEMC Instruments ® ® certifies that this instrument has been calibrated using standards and instruments traceable to international standards. We guarantee that at the time of shipping your instrument has met its published specifications. An NIST traceable certificate may be requested at the time of purchase, or obtained by returning the instrument to our repair and calibration facility, for...
- Page 3 Thank you for purchasing an AEMC Instruments Simple Logger ® ® For the best results from your instrument and for your safety, read the enclosed operating instructions, and comply with the precautions for use. These products must be used only by qualified and trained users. Signifies that the instrument is protected by double or reinforced insulation.
- Page 4 Precautions Before Use These instruments comply with safety standard EN 61010-1 (Ed 2-2001) or EN 61010-2-032 (2002) for voltages and categories of installation, at an altitude below 2000 m and indoors, with a degree of pollution of 2 or less ■...
- Page 5 Initial Setup The Simple Logger II (SLII) must be connected to DataView for configuration. ® ® To connect the SLII to your computer: 1. Install the DataView software. Make sure to select the Simple Logger II Control Panel as an option (it is selected by default). Deselect any Control Panels that you do not need.
- Page 6 Configuring the Instrument Before starting a recording on the instrument, various recording options should be configured. ■ To do this, select Configure from the Instrument menu. The Configure Instrument screen will appear and consist of multiple tabs that contain groups of related options. Detailed information for each option is available by pressing the Help button.
- Page 7 Repair and Calibration To ensure that your instrument meets factory specifications, we recommend that it be scheduled back to our factory Service Center at one-year intervals for recalibration or as required by other standards or internal procedures. For instrument repair and calibration: You must contact our Service Center for a Customer Service Authorization Number (CSA#).
- Page 8 08/22 99-MAN 100401 v9 AEMC Instruments ® 15 Faraday Drive • Dover, NH 03820 USA Phone: (603) 749-6434 • (800) 343-1391 • Fax: (603) 742-2346 www.aemc.com © Chauvin Arnoux , Inc. d.b.a. AEMC Instruments. All Rights Reserved. ® ®...
Need help?
Do you have a question about the Simple Logger II Series and is the answer not in the manual?
Questions and answers