Advertisement
Quick Links
01865 767676
sales@unicol.com
www.unicol.com
Pillar Clamps - VCC1 & VCC2
VCC1
VCC2
Screen Size: 70"
Guide Max. Weight: 120kg
Revised 28/09/22
*Please check model specific details before installing*
WARNING
Please carefully inspect the product before assembling. If you notice any apparent damage, call your carrier
claims agent and do not continue the installation until it has been reviewed. Please watch for pinch points.
Do not put your fingers between moveable parts. Do not tamper with or disassemble any spring loaded
parts. Before installing, make sure that the supporting surface will support five times the combined load of
the solution and the hardware. Never exceed the maximum load capacity. Please also layout all components
to ensure that you have all of the required parts before proceeding (see BOM list on following page). Use of
this product for anything other than its specified use may result in failure or personal injury. This product is
intended for indoor use only. We recommend using a qualified trades person for installation. Use an assistant
or lifting equipment to lift and position products.
For support, please call: +44 (0)1865 767676 or email: sales@unicol.com
Advertisement
Related Manuals for Unicol VCC1
Summary of Contents for Unicol VCC1
- Page 1 This product is intended for indoor use only. We recommend using a qualified trades person for installation. Use an assistant or lifting equipment to lift and position products. For support, please call: +44 (0)1865 767676 or email: sales@unicol.com...
- Page 2 COMPONENTS EQUIPMENT Straps Connecting Bars Studding with Fixings Fixing Cover VCC1 (VCC2) 1 (0) Fixing Cover with Arm VCC1 (VCC2) 1 (2) NOTE: Each VCC is custom made to fit the pillar specified and once tightened clamp it in position.
- Page 3 01865 767676 sales@unicol.com www.unicol.com STEP 1 – Place both straps around your pillar, either on the floor or on a support. Place connecting bars into slots in straps and push the studding provided through the holes to attach them. NOTE: The open channel section of the bar must be positioned against the wall of the strap.
- Page 4 Tighten cover screws. The VCC1 has an arm on one cover only. The VCC2 has arms on both covers. PS1 Screen Adapter shown STEP 4 –...