IBM ThinkPad R32 2658 Maintenance Manual page 93

Notes:
1. When removing the system board from the bottom
cover, gently raise the side of the system board facing
the rear I/O ports; then pull out the system board.
2. In step 2, further pull out this latch before the system
board is attached to the lower case.
3. Thermal Pad must be replaced when either Heat Sink
Module, CPU or System Board is replaced. Thermal
Pad is stuck on the bottom side of Heat Sink Module
with adhesive. Do not re-use the thermal pad.
1260 I/O Port Bracket Disassembly
v "1010 Battery Disassembly" on page 63
v "1020 Mini-PCI cover and Mini-PCI card Disassembly"
on page 64
v "1040 Hard Disk Drive Disassembly" on page 66
v "1060 CD-ROM Disassembly" on page 67
v "1070 Keyboard Disassembly" on page 68
v "1100 Middle Cover Disassembly" on page 71
v "1110 CDC Cover Disassembly" on page 72
v "1170 LCD Disassembly" on page 77
v "1180 Keyboard bezel Disassembly" on page 78
v "1240 Speaker Disassembly" on page 85
v "1250 System Board Disassembly" on page 86
3
MT 2658/2659/2677
2
87