Radio Mode - auna Franklin Instruction Manual

RADIO MODE

Manual station search
1. Press the TUNER button and select the desired frequency range.
2. Press the button
3. Adjust the volume with the volume control to the desired loudness.
Automatic station search
1. Press the TUNER button and select the desired frequency range.
2. Press and hold the or button for 1-2 seconds and then release it.
3. The unit automatically starts scanning and stops when a radio station is
found.
4. Repeat steps 3 and 4 until you have found the desired radio station.
5. Adjust the volume with the volume control to the desired loudness.
Save a radio station
Up to 20 radio stations can be stored in the station memory.
1. Press the TUNER button and select the desired frequency range.
2. Select the desired radio station using the manual or automatic search.
3. Press the MEM/CLK-ADJ key to activate the programming mode.
4. Press the REP/RAN/PRE-DN or +10/PRE-UP button to select the desired
memory location for storage.
5. Press the MEM/CLK-ADJ button again to confirm the setting.
6. Repeat steps 2 to 5 to save more stations.
7. To recall a stored station, press the REP/RAN/PRE-DN or +10/PRE-UP
button repeatedly until you find the desired station.
Note: In the event of a power failure or if the plug is pulled out, all
stored stations are deleted. We therefore recommend that you switch
the system to standby mode and not disconnect it completely from the
mains.
or to select the desired station.
EN
35