Getting Started - auna Franklin Instruction Manual

EN
34

GETTING STARTED

Installation
• Unpack all parts and remove the protective material.
• Do not connect the unit to the mains until you have checked the mains
voltage and made all other connections.
• Do not cover any ventilation openings and ensure that there is a
clearance of several centimetres around the unit for ventilation.
Connection
1. Connect the mains cable to a power socket and switch on the main
switch on the back of the unit.
2. When you connect the unit to the mains for the first time, the unit
switches to standby mode.
3. Connect the speaker cable to the speaker connector on the back of the
unit.
4. Switch the unit on by pressing the POWER button.
Setting the clock
1. Switch the unit to standby mode.
2. Press the button MEM/CLK-ADJ. The first two digits of the display flash
[00]. Press the
Press the MEM/CLK-ADJ button again to save the current hour.
3. The third and fourth digits flash [00]. Press the
repeatedly to set the current minute. Press the MEM/CLK-ADJ button
again to save the current minute.
4. To switch between 12-hour and 24-hour mode, press the STOP button.
Note: In the event of a power failure or if the plug is pulled out, the time
must be completely reset. We therefore recommend that you switch
the system to standby mode and not disconnect it completely from the
mains.
or button repeatedly to set the current hour.
or button