Infrequent Or Occasional Use; Starting The Engine - HONDA marine BF2.3DH Owner's Manual

The transom angle adjusting bolt is
used to adjust the angle of the
outboard motor in the normal
operating position (p. 34).
1. To adjust, first tilt the outboard
motor so it is not resting on the
bolt.
There are four adjustment
positions.
2. Loosen the wing nut to free the
adjusting bolt.
3. Adjust the angle of the outboard
motor, and tighten the wing nut. Be
sure that the bolt head and wing nut
are seated in one of the four
adjustment positions.
To prevent damage to the outboard
motor or boat, make sure the transom
angle adjusting bolt is tight.
INFREQUENT OR
OCCASIONAL USE
If your outboard motor will be used
on an infrequent or intermittent basis,
please refer to the fuel section of the
STORAGE chapter (p. 54) for
additional information regarding fuel
deterioration.
OPERATION

STARTING THE ENGINE

EMERGENCY STOP SWITCH CLIP
EMERGENCY STOP
SWITCH
EMERGENCY STOP SWITCH
LANYARD
1. Put the emergency stop switch clip
in the emergency stop switch, and
attach the emergency stop switch
lanyard securely to the operator or
to the operator's PFD (Personal
Flotation Device).
The engine will not start or run
unless the emergency stop switch
clip is in the emergency stop
switch.
25