Parts Description - Makita XCV11 Instruction Manual

Switch action
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
slide switch actuates properly and returns to the
"OFF" position when the rear of the slide switch
is depressed.
According to your work need, you can choose two types
of the suction power; normal "1" or high "2".
To start the cleaner, set the switch lever to "1" or "2"
side.
To turn off the cleaner, set the switch lever to "O" side.
Fig.5
► 1. Switch lever
Auto-suction stop during wet
suction operation
WARNING:
Do not use for a long time while
the float is at work. Using the cleaner with its float
at work for a long time can cause overheat, resulting
in the cleaner deformation. In the worst case, it may
lead to smoke emission or fire.
WARNING:
Do not pick up foam or soapy
liquid. Picking up foam or soapy liquid can cause
foam to come out of air exit before the float works.
Continuing to using in this condition may cause an
electric shock and breakage of the cleaner.
The cleaner has a float mechanism that prevents water
from immersing into the motor when picking up more
than a certain amount of water. When the tank is full
and the cleaner no longer picks up water, switch off the
cleaner and empty the tank.
Carriage handle
When carrying the cleaner, carry it by holding the handle on the
head. The handle is retractable at the head when not in use.
Fig.6
NOTE: When water is in the tank, switch off the
1
cleaner and empty the tank before carrying. The
water inside may leak.

PARTS DESCRIPTION

For picking up dry dust
Fig.7
► 1. Tank cover 2. HEPA filter 3. Damper 4. Prefilter 5. Tank
NOTICE:
dry dust.
NOTE: Use the prefilter and dumper only when pick-
ing up dry dust with HEPA filter. If you use the prefilter
and dumper for picking up water, the water suction
capacity may be reduced.
8 ENGLISH
Use the HEPA filter when picking up
1
2
3
4
5