Configuring Intrusion Control Units; Configuring A Sintony Si410; Si410 Connectivity Overview - Siemens DMS8000 MP4.81 Operation Manual

2 Configuring intrusion control units

2.1 Configuring a Sintony SI410

2.1.1
Building Technologies
CPS Fire Safety
This section describes how to configure control units. The list includes:
SI410
l
SPC4000/SPC5000/SPC6000
l
CS6 Guarto
l
CS4
l
CS440
l
CZ12
l
The Sintony SI410 is an intrusion detection unit with individual addressing and
access control capability. It can handle detection lines on which transponder units
can concentrates alarm inputs and outputs . Inputs can be operated in groups,
organised in Rooms , Wards , and Clusters .
The physical and logical configuration for the unit is first defined for the hardware
unit set-up by means of a PC tool ( SYLCOM ), and then ported to the Composer
environment using a metafile generated by a special tool, the Sintony Uploader ,
distributed with the DMS8000 products.
The Sintony SI410 can communicate to DMS8000 systems over a serial line or via
network connection using an internal (SMN36 or SMN42/43) or external (NK8000
or 3rd party) network adapter.
SI420 model
The SI420 model also exists and it is functionally equivalent to the SI410 as far as
the management station functions are concerned. In this document, the name
SI410 is used hereafter to refer to either model.

SI410 connectivity overview

A - Serial connection
SI410 can be connected to DMS8000 over a serial line. The service PC running the
SI410 SYLCOM tool can connect via another serial port or over a LAN link. Note
that the LAN connection requires the SMN36 (or the newer SMN42/43) module or
an external adapter (see the Network Connectivity Guide ).
DMS8000 connection SYLCOM tool connection (serial)
MM8000 station
RS232
SAQ18 cable (*)
J10
(*) The small printer
circuit on one end of the
cable is labelled SMQ18.
SI410 serial connectivity: DMS8000 and Sylcom Tool
Configuring intrusion control units
Configuring a Sintony SI410
MM8000 station
RS232
SAQ18 cable
J10 Sylcom
SI410
RS232
J7
SAQ11
cable
2
SYLCOM tool connection (LAN)
MM8000
Tool
station
LAN
RS232
SAQ18
J1
cable
Ethernet
SI410
10-base-T
SMN36/42
A6V10359489_a_en
30.09.2016
9