Scandomestic SV 10 Series User Manual page 29

and install the door onto lower hinge
(left), then close the door carefully.
5. Fix spare top hinge (left) (10) onto left
top of cabinet with 4 screws (1), then
adjust door. (Fig.D)
Note: This is a two person operation.
For model SV 100-series, SV 110-
series, SV 120-series
(with full glass door)
1. Open the door and remove the two
screws under the right bottom corner
of the door that are used to hold the
right lower hinge to the door. Be care-
ful to hold the door with hands from
dropping after removing the screws.
2. Put down to remove the door and place
it on a padded surface to prevent
scratching it.
3. Remove the decorative nails on the top
of the door.
4. The door revolves 180 degrees. Install
the decorative nails to the top right of
the door.
5. Remove the door shaft from the right
upper hinge. Install the new left door
shaft that from the plastic bag includes
the instruction manual and tighten it
on the left upper hinge.
6. Take out the door body support block at
the right lower hinge, and then install
it to the left lower hinge.
7. Remove the right lower hinge supporter
with the adjusting washer. Install the
left lower hinge supporter from the
plastic bag that includes the instruction
manual. Make sure to put the adjusting
washers at the designated position.
8. Locate the door to the designated posi-
tion making sure that the door shaft
enters the door hole at the left upper
corner of the door. Install the two
screws that are used to connect the left
lower hinge with the door and tighten
them before the door is leveled. Then
remove the handle from the left side
and install it on the right side of the
door.