Scandomestic SV 10 Series User Manual page 27

For SV 80-series/ SV 90-series
•
When removing any of these shelves
out of the rail compartment, To fit or
remove the shelf, tilt the shelf as per
the diagram and simply pull out, or
push in the shelf until it sits on the
support brackets securely.
For SV 10-series,
SV 100-series/SV110-series/
SV 120- series/SV 130-series
•
Put the shelf gap (left and right) under
the square plastic block, uptilt the
shelf, then pull the shelf from the
Wine Cooler.
Note
•
If the unit is unplugged, power lost, or
turned off, you must wait 3 to 5
minutes before restarting the unit. If
you attempt to restart before this
time delay, the Wine Cooler will not
start.
•
When you use the wine cooler for the
first time or restart the wine cooler af-
ter having been shut off for a long
time, there could be a few degrees
variance between the temperature
you select and the one indicated on
the LED readout. This is normal and it
is due to the length of the activation
time. Once the wine cooler is running
for a few hours everything will be back
to normal.
Door Lock
(For SV 100-series/SV 110-se-
ries/SV 120-series/SV 130-series)
Your unit is provided with a lock and key
combination.
The keys are located inside the plastic bag
that contains the User's Guide. Insert the
key into the lock and turn it counterclock-
wise to unlock the door. To lock the door
do the reverse operation making sure
metal pin is engaged completely. Remove
the key and place it in a secure place for
safekeeping.
How to change
the door opening
This appliance has reversible doors but is
delivered with a right hinged door. The left
hand hinge kit comes with the unit (in the
box), should you wish to reverse the hinge
on your unit.
For model SV-10 series,
SV 80-series and SV 90-series
1. Lower hinge (Right)
2. Screws
3. Door axis
4. Door
5. Top hinge (Right)
6. Hinge Screws
7. Top hinge (Left)
8. Decorative nail
9. Lower hinge (Left)