Renesas dialog semiconductor DA913 30 Series Quick Start Manual

AN-1-00163
DA913x Quick Start
1

Quick Start

Figure 1: DA913x-30 Jumpers and headers location
Connections from the table below are highlighted in green
Table 1: Jumpers and headers overview
Connection Description
J14 IC_EN
J9 GPIO header
J2 - J3 VSYS - GND
J4 - J25 VOUT1 - GND
J5 - J19 VOUT2
GND
Note 1 VOUT2 is connected to VOUT1 on DA9130 boards.
1.1

Instructions

Make sure the jumper configuration is correct. IC_EN has to be on pull-up position and VDDIO
connected to VSYS.
Connect a bench PSU to VSYS (J2, positive) and GND (J3, return) and make sure it can supply 4V
and 5A. Measure the outputs on VOUT1 (J4) and VOUT2 (J19).
Pull-up and pull-down jumpers may be needed on GPIOs 0 to 2 depending on the configuration.
Application Note
CFR0014
Default
Jumper fitted to pull-up position
Jumper between VSYS and
VDDIO
Supply from PSU, 4V - 5A
recommended
Channel 1 output
[Note 1] - Channel 2
Revision 1
1 of 1
Location
Top-left, 4th jumper from
the left
TOP left, jumper on
positions 21 and 23
Left of EVB
Top right of EVB
[Note 1] output Bottom right of EVB
26-Nov-2021
© 2022 Dialog Semiconductor