Table of Contents
Advertisement
Figure 58. Removing the hard disk drive from the bracket
10. Go to "Completing the FRU replacement" on page 158.
150
Hardware Maintenance Manual
7. To install the new drive into the bracket, flex the bracket and align pin 1 ,
pin 2 , pin 3 , and pin 4 on the bracket with the holes in the hard disk
drive.
Important
Do not touch the circuit board on the bottom of the hard disk drive.
8. Connect the signal and power cables to the new hard disk drive.
9. Install the hard disk drive and bracket into the rear retainer and rotate down
until the two clips on the blue handle of the hard disk drive bracket snap into
place.
Hide quick links:
Advertisement
Table of Contents
