Replacing The Card Reader - Lenovo ThinkCentre M58 9960 Hardware Manual

Replacing the card reader

This section provides instructions on how to replace the card reader.
To replace the card reader:
Figure 62. Removing the card reader
10. Go to "Completing the FRU replacement" on page 158.
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
1. Open the computer cover. See "Opening the computer cover" on page 128.
2. Pivot the drive bay assembly upward to gain access to the card reader.
3. Locate the card reader.
4. Disconnect the card reader cable from the front USB connector on the system
board. See "Locating parts on the system board" on page 131.
Note: Make sure you note the location of the cable when you disconnect the
cable from the system board.
5. Remove the screw that secures the card reader to the chassis.
6. Remove the card reader from the chassis.
7. Install the new card reader into the chassis and align the screw hole in the
card reader with the hole in the chassis.
8. Install the screw to secure the card reader to the chassis.
9. Connect the card reader cable to the system board.
Chapter 9. Replacing FRUs - Desktop computers
153