Lenovo ThinkCentre A58 5473 User Manual page 44

2. Ensure that the cables are routed correctly before lowering the drive bay
Figure 29. Cable routing
3. Lower the drive bay assembly and place the drive locks to the locked position.
4. If you removed the front bezel, reinstall it by aligning the three tabs on the
5. Close the computer cover.
6. If a computer cover lock is installed, lock the computer cover.
7. Reconnect the external cables and power cords to the computer. See "Locating
8. To update your configuration, see Chapter 4, "Using the Setup Utility," on page
Note: In most areas of the world, Lenovo requires the return of the defective CRU.
Obtaining device drivers
You can obtain device drivers for operating systems that are not preinstalled at:
http://www.lenovo.com/support
Installation instructions are provided in readme files with the device-driver files.
36
User Guide
assembly.
Important
Correctly route all power supply cables to avoid interference with the
drive bay assembly. Keep cables clear of the hinges and sides of the
computer chassis.
Otherwise, you cannot close the computer cover.
front bezel with the corresponding holes on the chassis and pivoting the front
bezel inward until it snaps into position.
connectors on the rear of your computer" on page 7.
47.
Information about this will come with the CRU or will come a few days
after the CRU arrives.