Lenovo ThinkCentre A58 5473 User Manual page 27

Installing a drive in bay 2
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to install an optical drive or an
additional hard disk drive in bay 2.
To install an optical drive or an additional hard disk drive in bay 2:
1. Open the computer cover. See "Opening the computer cover" on page 12.
2. Remove the metal shield from the drive bay by using a flat-blade screwdriver
to gently pry it loose.
3. Install the optical drive retainer on the left side of the optical drive to be
installed.
Figure 13. Installing the retainer
4. Slide the drive into the bay until it locks into position.
Figure 14. Installing the drive
5. Pivot the drive bay assembly upward to gain access to the cable connections
and connect the signal cable and the power cable for the drive.
6. Continue at "Connecting a SATA drive" on page 20.
Chapter 2. Installing options and replacing hardware
19