Selecting Or Changing The Startup Device Sequence; Exiting From The Setup Utility Program - Lenovo IdeaCentre K220 5358 User Manual

Selecting or changing the startup device sequence

Exiting from the Setup Utility program

the F12 key rather than leaving it pressed when turning on the
computer.
3. Select the desired startup device from the Startup Device Menu and
press Enter to begin.
Note: Selecting a startup device from the Startup Device menu does
not permanently change the startup sequence.
To view or permanently change the configured startup device sequence,
do the following:
1. Start the Setup Utility program (see "Starting the Setup Utility program"
on page 16).
2. Select Advanced BIOS Features.
3. Select the devices for the 1st Boot Device, the 2nd Boot Device, the 3rd
Boot Deviece and the 4th Boot Device.
4. Press ESC to return the Advanced BIOS Features and then Save
changes and Exit.
If you have changed these settings and want to return to the default
settings, select Load Optimal Defaults on the Setup Utility menu.
When you finish viewing or changing settings, press Esc to return to the
Setup Utility program menu (you might have to press Esc several times).
If you want to save the new settings, select Save changes and Exit before
you exit. Otherwise, your changes will not be saved.
Chapter 5. Using the Setup Utility
21