Table of Contents
Advertisement
Hardware Maintenance Manual
Replacing an adapter
46
4. Position the new memory module over the memory connector. Make
sure the notch
on the memory aligns correctly with the connector
key
on the system board. Push the memory module straight down
into the connector until the retaining clips close.
5. Refer to the "Completing the installation".
Attention
Do not remove the computer cover or attempt any repair before
reading the "Important safety information" in the Safety and Warranty
Guide that was included with your computer or in the Hardware
Maintenance Manual (HMM) for the computer. To obtain copies of
the Safety and Warranty Guide or HMM, go to the Support Web site at
http://www.lenovo.com/support.
To replace an adapter:
1. Remove the computer cover. Refer to "Removing the computer cover".
2. At the rear of the computer, press the release button
adapter latch
and remove the adapter by pulling it straight out of the
adapter connector.
to open the
Hide quick links:
Advertisement
Table of Contents
