Table of Contents
Advertisement
he BK-3 as a USB player
DI (SMF) and audio songs stored
Selecting a Song or Rhythm on a USB
is also possible to select rhythms
me way as the internal rhythms.
Memory
d to the USB memory using your
1.
Connect an optional USB memory to the BK-3 or, if it was
e the BK-3 as a
already inserted, press the [USB MEMORY] button
new song and rhythm files to
emory stick).
nd (M-UF-series). We cannot
er USB memory is used.
Ikoner i venstre side af displayet angiver filtype eller mappe:
your BK-3.
The icons to the left of the file names indicate the file type:
Icon
SB memory all
2.
3. Brug [UP] eller [DOWN] knapperne for at vælge den fil som du ønsker at afspille.
Use the [UP] or [DOWN] button to select the file you want
firmly in place.
to play back or display.
3.
Press the [ENTER] button to load the file.
while this unit is turned on. Doing
4. Tryk [ENTER] for at vælge den ønskede fil.
or the data on the USB memory.
The [USB MEMORY] button now lights to indicate that you selected
a file on the USB memory.
If the file you need is located inside a folder, you must first select
Hvis den ønskede fil er placeret i en folder (Mappe), vælges først folder ved at trykke
ries with a capacity of up to
that folder, press the [ENTER] button to see its contents and then
select the file. If you opened a folder by mistake, press the [EXIT]
[ENTER] og efterfølgende vælges den ønskede fil i mappen.
button to return to a higher level.
MEMO
nd play back
Format
Afspil en Song fra en USB-hukommelse
Playing Back a Song or Rhythm from
0 or 1
a USB Memory
• MPEG-1 Audio Layer 3
1. Vælg en Song (SMF- eller audio-fil) på USB-hukommelsen som forklaret i forrige
• Sampling frequency: 44.1kHz
If you selected a rhythm, see "Playing Back Rhythms" p. 24, because
operation is the same as for internal rhythms.
• Bit rate: 32/40/48/56/64/80/96/112/
afsnit.
128/160/192/224/256/320 kbps,
In the following, we will therefore only show you how to play back song
VBR (variable bit rate)
files located on a USB memory.
• 16-bit linear
NOTE
• Sampling frequency: 44.1 kHz
2. Afspil sang ved at trykke [START/STOP].
• Stereo/mono
1.
Select a song (SMF or audio file) on the USB memory.
See "Selecting a Song or Rhythm on a USB Memory" p. 28.
2.
Press the [START/STOP] /[*/,] button to start playback.
3.
3. Hvis det er nødvendigt, så kan Tempo på sang ændres ved brug af [TEMPO]
knapperne.
Hvis du afviger meget fra det normale tempo på en mp3/Audio fil, så vil filen lyde
underligt. (Den maksimale tempo ændring er +/-25%)
4.
After a few seconds, the display shows the contents of the USB
memory.
Explanation
Rhythm file
SMF file
Audio mp3 file
Audio WAV file
Folder
Press and hold the [EXIT] button to return to the main page.
The BK-3 has no internal memory where you could store SMF or
audio files.
The [*/, ] button's indicator lights and song playback starts.
The [*/, ] button's indicator lights and song playback starts.
If necessary, you can change the song's playback tempo:
3.
If necessary, you can change the song's playback tempo:
• Press the TEMPO [] or [] button to decrease or increase the
tempo.
• Press the TEMPO [] or [] button to decrease or increase the
tempo.
NOTE
If you set a tempo value close to the upper or lower limit for an
NOTE
mp3 or WAV file, playback may sound a little strange.
If you set a tempo value close to the upper or lower limit for an
mp3 or WAV file, playback may sound a little strange.
• Press the [TAP TEMPO] button at least three times at the desired
tempo. (This function is not available if you selected an audio file
• Press the [TAP TEMPO] button at least three times at the desired
(WAV or mp3).)
tempo. (This function is not available if you selected an audio file
(WAV or mp3).)
TheBK-3 calculates the intervals between your presses and sets the
corresponding tempo value.
TheBK-3 calculates the intervals between your presses and sets the
corresponding tempo value.
MEMO
Simultaneously press the TEMPO [] and [] buttons
MEMO
("STANDARD") to return to the rhythm's preset tempo.
Simultaneously press the TEMPO [] and [] buttons
("STANDARD") to return to the rhythm's preset tempo.
Press the [START/STOP]/[*/, ] button again to pause song
Activating the 'Play All Songs' parameter for the USB memory
Activating the 'Play All Songs' parameter for the USB memory
You can use the following buttons to control song playback (see the
gray legends):
You can use the following buttons to control song playback (see the
gray legends):
Button
Explanation
Button
Explanation
Starts or pauses song playback.
Starts or pauses song playback.
Stops song playback and allows you to return to the
beginning of the current song.
Stops song playback and allows you to return to the
beginning of the current song.
Rewinds the song.
Rewinds the song.
Fast-forwards the song.
Fast-forwards the song.
Activating the 'Play All Songs'
Activating the 'Play All Songs'
parameter for the USB memory
parameter for the USB memory
Activating the 'Play All Songs' function
Activating the 'Play All Songs' function
1.
Connect an optional USB memory to the BK-3 or, if it was
1.
already inserted, press the [USB MEMORY] button.
Connect an optional USB memory to the BK-3 or, if it was
After a few seconds, the display shows the contents of the USB
already inserted, press the [USB MEMORY] button.
memory.
After a few seconds, the display shows the contents of the USB
2.
memory.
Use the [UP] or [DOWN] button to select the folder that
2.
contains the songs you want to listen to.
Use the [UP] or [DOWN] button to select the folder that
3.
contains the songs you want to listen to.
Press the [ENTER] button to open the folder.
3.
4.
Press the [ENTER] button to open the folder.
Use the [UP] or [DOWN] button to select the song where
4.
you want playback to start.
Use the [UP] or [DOWN] button to select the song where
5.
you want playback to start.
Press [ENTER] to confirm your selection.
5.
6.
Press [ENTER] to confirm your selection.
Press the [USB MEMORY] button to activate the playback
6.
function of the selected and all subsequent songs.
Press the [USB MEMORY] button to activate the playback
The following message appears:
function of the selected and all subsequent songs.
The following message appears:
NOTE
STL files contained in the selected folder will be ignored when
NOTE
you start playback (see below).
STL files contained in the selected folder will be ignored when
QUICK GUIDE
35
Advertisement
Table of Contents
