Table of Contents
Advertisement
SECTION 1 INSTALLATION INFORMATION
SAFETY FIRST - READ THE INFORMATION AT THE FRONT OF THIS BOOK.
1.1 TRACTOR VALVE CONNECTION.
The conveyor rams require an oil supply from a double acting valve. The supply to the rams should be enough to
operate the conveyor rams at a minimum of 5 litres/min. If the tractor has a high flow pump e.g. 100 litres/min, it
must be reduced in a way approved by the individual tractor manufacturer.
1.2 CONTROL DESK (EC2005) INSTALLATION.
The control box can be either installed in loader vehicle, so the user can control some features of the C12 machine
without leaving the cab. The electric control desk should be fitted inside the cab conveniently situated either side of
the operator using the suction cup. If the loading vehicle does not have a 3 pin plug, an adapter cable EC2002 is
provided with the machine, which will fit into a standard cigarette socket.
1.3 JUNCTION BOX (EC2004) INSTALLATION.
Provided with the machine, is a 3 pin tractor power supply cable with fuse holder & eyelets (EC2001) to be wired
directly to the tractor's battery. The controls have been designed to be supplied through this cable and
WARRANTY SHALL BE INVALIDATED if this cable is modified. When fitting to the tractor, make sure that the
brown/red cable (positive) is fitted to the positive terminal of the battery. Failure to use this supplied power supply
cable could result in the tractors wiring loom over heating and causing a fire.
UNDER NO CIRCUMSTANCES SHOULD A FUSE WITH A HIGHER RATING THAN 15 AMPS BE FITTED AS
THIS WILL INVALIDATE WARRANTY. If a higher rated fuse is fitted whilst the power cable is connected to the
incorrect polarity the control desk will suffer severe damage and have to be replaced. Also a higher rated fuse will
give no protection from power surges when connected correctly.
When fitting the cable, make sure it is routed away from high temperature and moving engine components. Avoid
sharp edges that would damage the cable, particularly when passing the cable through a bulkhead.
Junction box cable: route the machine cable into the cab making sure it is kept away from the rear wheels and
any pinch points between the PTO shaft and link arms. Where possible, route into the cab through cable entry
points on the tractor, allowing the rear window to be kept closed during use. Plug the cable connector into the
socket on the box and secure by engaging the locking clip.
1.4 ELECTRONIC CONTROL DESK STORAGE.
When the machine is not being used, the control box should be stored in a dry location safely away from the
machine to prevent the possibility of water ingress which may damage the electronics. The plug on the end of the
machine cable should be kept clean and stored safe from damage.
1.5 ELECTRONIC CONTROL MAINTENANCE.
Teagle Machinery Ltd should be contacted immediately if any problem is found with any aspect of the electronic
controls during the warranty period. The correct course of action shall be advised by a member of the
manufacturer's Technical Staff.
Failure to comply with this request shall INVALIDATE THE WARRANTY. Before maintaining any part of the
electronic controls and wires, disconnect the 12v supply as failure to do so may result in damage to electronic
components.
3
Advertisement
Table of Contents
