The Water Inlet Hose And Water Filter; Connecting The Water Inlet Hose And Water Filter - Baumatic TITAN2 Instruction Manual

4)

The water inlet hose and water filter

o The water pressure should be 2 bar or higher to allow the
o Care should be taken to make sure that the water inlet does not
o The water filter only filters the water; it does not eliminate
o The water filter life will depend on how often you dispense water
o IMPORTANT: The water inlet MUST be connected to your cold

Connecting the water inlet hose and water filter

2) At the rear of the appliance, you will eventually connect a holder
which you will clip the water filter into (on the right or left hand side).
o You should measure an appropriate distance from the tap along
o IMPORTANT: Put the water filter in a position where it will be
Get user manuals: See SafeManuals.com
Place the top hinge cover back into position and using a
screwdriver, fully tighten it to the top of the cabinet.
icemaker to operate correctly.
come into contact with any hot surfaces.
bacteria or microbes.
and ice. We recommend that the water filter is replaced at least
every 6 months.
water supply.
the water inlet hose and mark a position where you will want to
place the water filter.
able to clip into the holder that you will position on the rear of
the appliance.
1) Place the seal inside of
connector A and then screw
connector A securely onto your
cold water mains supply. Push
the water inlet hose firmly onto
connector A.
35