Table of Contents
Advertisement
•
Update Firmware:
allowing you to update the firmware of the currently attached device. Do
not update the firmware of a device with a flat battery – allow it to charge
partway first. Note that the software will apply a firmware update to the
version packaged with your PC software. This can be either an "update"
or "backdate" as you choose.
•
Clear List:
This will clear the large central list of diagnostic information
which was collected by using the other functions.
•
Mem Check:
This is an internal CamNtech test to report on the memory
chips of the device.
•
Erase:
This triggers a full erase of the device memory. It should only be
performed if you are certain you wish to erase any recording data on the
device. It is also performed automatically when you wish to set up for a
new recording – there is no need to use this button.
•
Acc Check:
This is an internal CamNtech test to report on the
accelerometer chips of the device.
•
Enter Boot:
The Actiheart connected will be asked to leave the normal
firmware operating mode and enter "boot" mode. It is not necessary to
perform this manually before a firmware update.
•
The Actiheart connected will be asked to leave the "boot"
Exit Boot:
mode and enter its normal operating mode. This will normally happen
automatically in use, but may be applied manually immediately after a
battery charge, if the centre heading indicates that the device is in "boot"
mode.
Actiheart User Manual 5.1.31 (Jun 2022)
Clicking will open the firmware update window,
16
Advertisement
Table of Contents
