Menu Structure Time Setting function Mode Temperature A/F/AF mode Preset temperature Period display Power Button Arrow keys Menu button Return button Confirm button Points to note: To turn off the heating Tap the power button once to turn off the heating; the towel rail will remain ON To turn off both –...
Startup Wizard Switch on the thermostat by pressing the Power button. If power has been applied for the first time, you will have to set the date and time. Date MM YY Date Day of the week 1. Press 4 times to select Date and press confirm.
Page 5
Manual Mode 1. Press once to select Mode and press confirm. 2. Use the arrow keys to select Manual mode °C 24.0 and press to confirm. 3. Use the arrow keys to set the temperature and press to confirm 4. Press twice to go back to the main screen Pre-programmed schedule The thermostat comes with pre-programmed schedule for easy and economic heating control...
Automatic mode (2 settings) Mode 1. Press once to select Mode and press confirm. 2. Use the arrow keys to select Automatic mode and press to confirm. 3. Press twice to go back to the main screen. 4. Press twice to select Schedule and press to confirm.
Page 7
Automatic mode (4 settings) Mode 1. Press once to select Mode and press confirm. 2. Use the arrow keys to select Automatic mode and press to confirm. 3. Press twice to go back to the main screen. 4. Press twice to select Schedule and press to confirm.
Page 8
Heated towel rail The towel rail is programmed to remain on for 3 hours by default. The following table shows the default setting where the towel rail is ON only twice a day and settings 2 and 3 are blank. Setting Setting 1 5:30...
Vacation setting Mode 1. Press once to select Mode and press confirm. 2. Use the arrow keys to select Vacation mode and press to confirm. 3. Use the arrow keys to set the number of days you will be away and press to confirm 4.
Engineering Settings 1. Press and hold for 3 seconds to enter the internal setting operation. 2. Use the up and down arrow keys to select the number to change the setting and press to confirm. 3. Press to leave the internal setting screen. Setting Parameter Default...
Troubleshooting Error messages – If a fault or error occurs, the thermostat will display one of the following error messages: The measured air temperature is below the thermostat’s display range. Heating is activated. The measured air temperature is above the thermostat’s display range.
Page 12
Warmup New Zealand Ltd T 0800 927 687 E info@warmup.co.nz W www.warmup.co.nz...