Advertisement
Quick Start Guide
Pentax 425-VDN
This Guide was written using FieldGenius version 5.0.1.0
Procedure
1. Turn on the instrument
2. Level the instrument
3. On your instrument press ESC and Light button to access HELP
4. Press F2 and F1 to navigate to item 23 "801 Setup Com."
5. Pick F5 to SELECT
6. Verify that the communication parameters match the following:
BAUD RATE:
DATA LENGTH:
PARITY BITS:
STOP BITS:
SIGNAL CONTROL:
XON/XOFF
THROUGH COMMAND:
7. Press ESC until you return to the Main Measuring Screen:
8. In FieldGenius start or open an existing project. Press the Main Menu button
Instrument Settings. On the Instrument Settings screen, select Total Station.
September 9, 2011
9600
8
NIL
1
OFF
OFF
NIL
Settings
Page 1 of 3
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Pentax 425-VDN
Summary of Contents for Pentax 425-VDN
- Page 1 Quick Start Guide Pentax 425-VDN This Guide was written using FieldGenius version 5.0.1.0 Procedure 1. Turn on the instrument 2. Level the instrument 3. On your instrument press ESC and Light button to access HELP 4. Press F2 and F1 to navigate to item 23 “801 Setup Com.”...
- Page 2 Quick Start Guide 9. Create a new profile by selecting Add, entering a name, picking Save, and finally picking Edit: 10. Match the following on the Model and Communication screen: September 9, 2011 Page 2 of 3...
- Page 3 Quick Start Guide 11. Specify the EDM settings and reflector offsets you want to use on the EDM Settings screen. 12. Specify the tolerances you want to use on the Tolerance Settings screen. 13. There is nothing to set on the Search Settings screen. 14.
Need help?
Do you have a question about the 425-VDN and is the answer not in the manual?
Questions and answers