3. Use two or more screws to fix the back cover to the wall. Connect the power cables (V1, V2) and
communication cables (F1, F2) to the terminals on the back of the front cover with
adjusting to a suitable length.
4. When connecting the power cables to V1 and V2, fasten the PCB terminal screws (CN5) to a torque of 6
N·cm or less.
Screw size: M3 x 6
∙ You can connect up to 16 indoor units to a Wi-Fi Kit.
NOTE
참 고
10 (0.4) and over
10 (0.4) and
over
50 (2) and over
※ Be sure to secure space of at
least 10 (0.4 inch) mm (up/right/
left) and 50 (2 inch) mm (down)
around the back cover before fix-
ing the back cover on the wall.
Item
ⓐ
Power/communication terminals
ⓑ
Tracking/Reset button
ⓒ
Micro SD card slot
1-2
Unit: mm (inch)
10 (0.4) and over
Screw
holes
Back over
※ Fix the screws to the screw
holes.
Contents
ⓔ
※ Do not over-tighten the PCB
terminal.
Item
ⓓ
LED
ⓔ
Network PBA
ⓕ
Interface module PBA
Indoor unit
ⓕ
Wi-Fi Kit
ⓑ
ⓓ
ⓒ
PCB port
V1 V2 F1 F2
Contents
Samsung Electronics