Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Flash Technology R247-G
Summary of Contents for Flash Technology R247-G
- Page 1 R247-G with Wireless Control USER MANUAL SUPPLEMENT Technical Support: Email: customerservice@flashtechnology.com Toll Free: 1.800.821.5825 Fax: 1.615.261.2600 Web: flashtechnology.com 90469 Rev B - Road Holding Position Light ©2019 Flash Technology, LLC...
-
Page 2: Table Of Contents
R247-G with Wireless Control USER MANUAL SUPPLEMENT Contents Safety & Usage ................................2 Wireless Precautions ............................2 Warranty Disclaimer ............................2 Recycling ................................ 2 Abbreviations ..............................2 Limitations of scope ............................3 Theory of operation ............................3 Product Set-up ..............................3 Antenna Installation ............................ -
Page 3: Safety & Usage
R247-G with Wireless Control USER MANUAL SUPPLEMENT Safety & Usage The following symbols indicate important safety warnings and precautions throughout this manual: WARNING indicates that serious bodily harm or death may result from failure to adhere to the precautions. CAUTION indicates that damage to equipment may result if the instructions are not followed. -
Page 4: Limitations Of Scope
Vehicle Traffic Control Signal Heads 1.5 Limitations of scope This manual supplement provides an overview of the Flash Technology Road Holding Position Light with wireless remote control. This manual is supplemental to the general user manual and is not intended as a replacement. Consult the general user manual for all other aspects of setup, operation, maintenance and troubleshooting. -
Page 5: Mechanical Arrangement And Mounting
R247-G with Wireless Control USER MANUAL SUPPLEMENT 3.2 Mechanical Arrangement and Mounting Note: Consult the product user manual for an overview of mechanical components and general guidelines on system mounting and electrical connectivity. Note: For wireless operation, line-of-sight is required between the Handheld Controller and the receiving antenna on the system cabinet. -
Page 6: Non-Wireless Control
R247-G with Wireless Control USER MANUAL SUPPLEMENT 4.2 Non-Wireless Control For non-wireless 24-7 operation, see user manual excerpt below for configuration: Figure 3. OBUI Detail Note: When the system is configured for non-wireless 24-hour continuous operation, the system will no longer respond to commands sent by the wireless controller. - Page 7 R247-G with Wireless Control USER MANUAL SUPPLEMENT Note: In wireless mode, when activated by the Handheld Controller, the system will flash the beacons at the intensity that was preset through the system OBUI: The Handheld Controller sends on/off commnands only.
- Page 8 R247-G with Wireless Control USER MANUAL SUPPLEMENT Handheld Controller Beacon System Response Comments (HHC) Command Intensity DIAGNOSE 4 Not Used DIAGNOSE 7 Not Used DIAGNOSE 9 Not Used Table 1. System Commands and Functions 5.1.1 Handheld Controller Key Sequences The following are key sequences for applicable operating modes with wireless control ...
-
Page 9: Non-Wireless Control
R247-G with Wireless Control USER MANUAL SUPPLEMENT 5.2 Non-Wireless Control If continuous 24-hour operation without wireless control is required, set the product type through the OBUI to “r247” as per section 4.2 above. Note: When the product is configured in this manner, the beacon will beacon to flash once power is connected to the system. -
Page 10: Product Support
This product is covered by the Flash Technology warranty. Visit flashtechnology.com for additional information. Before contacting Flash Technology’s customer service department, please have the serial number of your product available, a brief description of the problem, as well as all details of the installation and recharging efforts (if applicable).