Advertisement
TURN TO THE LAST PAGE - WRITE DOWN THE REQUIRED INFORMATION!!!
•
Decide where the hardware components will be located. If necessary remove any dash
panels with removal tool.
•
Must be within reach of the diagnostic cable to be installed.
•
Must be protected from moisture, excessive dust/dirt, heat (away from heater vents) and
unobtrusive to driver operation or field of view.
•
Routing of the cable between the factory diagnostic port and the telematics device does not
cause excessive bending/kinking or areas where vibration may jeopardize the integrity of
the hardware.
•
Cabling must not impede function of any rotating or moving parts (ex. Steering
mechanisms, wiper mechanisms, or brake pedal)
•
Ensure that the mounting location has enough integrity to accommodate the additional
weight and vibration of the device.
Remove Cab-Mate One
STEP ONE
Unplug the cable from the Cab-Mate Connect
cradle. This cable will plug into the new cradle in
a later step.
STEP TWO
Detach the ball mount from the back of the cradle
by removing the four screws that secure it. It may
be easier to remove the mount by detaching the ball mount section. The ball mount section can
be attached to the new cradle assembly.
Cab-Mate Connect Cradle
PedigreeTechnologies.com | Support: (701)-499-0022
Before You Begin
Ball Mount on Cab-Mate Flex Cradle
3
Cab-Mate Connect to Cab-Mate Flex
Advertisement
